Emerson Liebert HiPulse E Series Communications Manual page 34

UPS System: HIPULSE E
Description of Protocol
UPS Power
0x0 = 30 kVA
0x1 = 40 kVA
0x2 = 60 kVA
0x3 = 80 kVA
0x4 = 120 kVA
0x5 = 160 kVA
0x6 = 200 kVA
0x7 = 300 kVA
0x8 = 400 kVA
0x9 = 500 kVA
0xA = 600 kVA
0xB = 800 kVA
Note Measurements with converted values
End of cell discharge
Pre-alarm for end of cell discharge= 'x.xx' Volts
Maximum cell voltage
Battery test threshold of cell
In some cases programming data values are not whole numbers.
In this case, if the measurement is not a whole number, it is multiplied by 100 before it is put into the Modbus/Jbus
RTU protocol buffer.
Note Measurements not present on the MSS
In certain cases, measurements of given quantities have no significance when running on MSS, but are significant when
running on UPS. In this case, if the RTU Jbus/Master Modbus requests these measurements the value returned will be
0xFFFF.
Page 5-14
= 'x.xx' Volts
= 'x.xx' Volts
= 'x.xx' Volts
(04/07)
Communication System Manual
(Modbus/Jbus Interface)