Commands Entered With The Operator Panel - Emerson Liebert HiPulse E Series Communications Manual

UPS System: HIPULSE E
Description of Protocol
5.3.3

Commands entered with the Operator Panel

This section describes all requests and commands which may be entered with the Operator Panel, specifying syntax and
response.
The following requests and commands are available:
a) Panel configuration request
b) Panel date and time request
c) Request for UPS alarm status
d) Request for values of current UPS measurements
e) Request for UPS programming settings
f) Request for Alarm History
g) UPS Alarm History command
h) UPS functional command
i) Date and time setting command
Note: The same commands\requests apply to UPS system configuration with MSS.
Page 5-4
Function 03 Read Holding Register
Function 03 Read Holding Register
Function 03 Read Holding Register
Function 03 Read Holding Register
Function 03 Read Holding Register
Function 03 Read Holding Register
Function 06 Write Single Register
Function 06 Write Single Register
Function 06/16 Write Single/Multiple Register
(04/07)
Communication System Manual
(Modbus/Jbus Interface)