Replacing The Monitor Battery; O-Ring Replacement - Verathon GlideScope GVL User Manual

Cleaning and Maintenance
Availability of disinfection products varies by country, and we are
unable to test products in every market. Please use the list of
recommended disinfectants in this manual to compare with
products available locally. If you are uncertain about the
suitability of a disinfectant, please contact Verathon Medical
Customer Care or your local Verathon
Representative.

Replacing the Monitor Battery

Under normal operating conditions, the battery will last 2 - 3
years; or approximately 500 charge/discharge cycles.
The battery is not user-replaceable. In case of battery
malfunction, do not attempt to replace the monitor battery. Any
attempts to replace the battery by unauthorized service
technicians will void the warranty. Please contact your
Verathon Medical
information on battery replacement.

O-Ring Replacement

A protective cap is attached to the top of the GlideScope
and on the end of the Cobalt Video Baton cable. The protective
cap contains a rubber O-ring that ensures an effective seal
during cleaning and sterilization. Over time, routine use will wear
out the O-ring. Replace the O-ring immediately if:
Any nicks or tears are visible
There is any liquid in the cable connector port after
cleaning
To replace an O-ring:
1. Remove the protective cap from the GVL
2. On the inside of the protective cap, pick the O-ring out of
the groove located at the base of the cap and remove.
3. Then stretch the replacement O-ring around the base of
the cap and insert it into the groove (Figure 33). Make
sure it is seated securely in the groove. Take care not to
nick the O-ring during insertion.
page 50
®
Customer Care Representative for more
GlideScope
® ®
GlideScope
®
port.
User's Manual
®
System
®
® ®
GVL