Set Up The Glidescope System; Setting Up The Glidescope System On The Mobile Stand - Verathon GlideScope GVL User Manual

Getting Started
2. Set Up the GlideScope
The GlideScope
configurations:
On a mobile stand (Figure 3)
In a hard shell case (Figure 4)
On an IV pole (Figure 5)
Setting up the GlideScope
Stand
(Refer to Figure 3, page 13)
Attach the center pole to the base (mobile stand only)
1. Remove the hex
bolt and washers
from the bottom of
the pole.
2. Insert the bottom
end of the pole into
the top of the base.
3. Flip the base over
and screw the bolt
and washers back
into place to secure
the pole to the
base. To keep the
center pole stable,
be sure to tighten the bolt securely.
page 24
®
System may be set up in one of three
®
®
System
System on the Mobile
Figure 11. Attaching the mobile
stand base to the center pole -
hardware stack-up.
®
GlideScope System
User's Manual