®
GlideScope
System
Preparing for First Use
Prior to using the GlideScope
the following steps:
1. Charge the monitor battery (instructions begin on this
page).
2. Set up the GlideScope
configuration (instructions begin on page 24).
3. Attach a video laryngoscope to the monitor (instructions
begin on page 32).
4. Connect the monitor to an external source such as a TV
screen or NTSC video monitor (optional).
5. Perform a functional check (instructions begin on
page 37).
1. Charge the Monitor Battery
The GlideScope
current) or battery power.
The GlideScope
power to the GlideScope
conditions, the battery will last approximately 90 minutes before
it needs to be recharged.
IMPORTANT! The battery must be fully charged prior to first
use.
For optimal battery life:
The battery must be fully charged before first use in
battery mode
When the battery is low, the
monitor front panel) will flash green for approximately
five minutes
User's Manual
®
®
®
System can operate on AC power (wall
®
Monitor contains a lithium battery that provides
®
Video Laryngoscope. Under normal
System for the first time, perform
System in your preferred
charge status
Getting Started
LED (on the
page 21