MOUNTING THE UNIVERSAL BRACKET
Position the bracket on the steel support beam beneath the frame under the cab. Drill holes to fit the
mounting bracket pattern and attach the universal mounting bracket to the machine. Figure below
shows the bracket mounted to the machine with the valve and hoses attached. NOTE: The mount-
ing bracket may need to be altered to allow the valve to fit in small spaces. Additional bolts
and nuts may be needed to properly mount the bracket and valve.
Universal
Mounting bracket
MOUNTING THE STEERING POSITION SENSOR
Figures below shows the approximate mounting position of the steering position sensor. Attach the
steering position sensor to the right side steering cylinder using the provided band clamps, screws
and brackets. NOTE: It may be necessary to fabricate a shield so that mud and debris do not
hit the sensor during operation.
Rear portion of
the steering
cylinder
NOTE: A hole in the boot will need to be cut for the linear sensor to slide through.
1903 without POWER BEYOND
Front portion of
the steering
cylinder
2