Table of Contents
Advertisement
CS-VG120KE / CU-VG120KE
12.4. DISASSEMBLY OF PARTS
12.4.1. Inspection points for the Indoor Electronic Controller
The Electronic Controller, a signal Receiver, a power monitor, as
indicator and a self diagnosis indicator display can be seen by removing
the Front Grille and Control Board Cover, as shown in the Fig. 1.
12.4.2. Indoor Fan Motor removal procedure
1. Remove the connector CN-MTR (GREEN) of Fan Motor and
connector CN-STM (WHITE) of stepping motor from the electronic
controller. Release the earth wire (YELLOW-GREEN) from the control
board and sensors from its holders. (Refer Fig. 1)
2. Remove the Control Board
The Control Board can be removed by releasing the top, left and right
tabs shown in Fig. 2, 3, 4.
Fig. 3
56
Fig. 1
Fig. 2
Fig. 4
Advertisement
Table of Contents
