Quick Start Guide
9
Zero trim the transmitter
Note
Transmitters are shipped fully calibrated per request or by the factory
default of full scale (span = upper range limit).
A zero trim is a single-point adjustment used for compensating mounting
position and line pressure effects. When performing a zero trim, ensure the
equalizing valve is open and all wet legs are filled to the correct level.
The transmitter will only allow three to five percent URL zero error to be
trimmed. For greater zero errors, compensate for the offset by using the
XD_Scaling, Out_Scaling and Indirect L_Type, which are part of the AI Block.
Procedure
1. To use guided setup:
2. To use manual setup:
28
a) Navigate to Configure → Guided Setup and select Zero Trim.
b) The method will execute the zero trim.
a) Navigate to Overview → Calibration → Sensor Trim and
select Zero Trim.
b) The method will execute the zero trim.
March 2020