Parameters Of The F-Tm Count - Siemens Simatic ET 200SP Equipment Manual

Parameters/address space

4.5 Parameters of the F-TM Count

4.5 Parameters of the F-TM Count
The following parameter settings are possible:
Table 4- 3 Settable parameters and their default setting
Parameter
F-parameters
Manual assignment of
F-monitoring time
F-monitoring time
1
F-destination address
TM-C parameters
Signal Monitoring
Encoder related parameters
Signal type
2
Invert direction
Pulses per revolution
Reaction to signal N
Counter parameters
High counting limit
Start value
Low counting limit
Reaction to violation of
a counting limit
Reset when counting
limit is violated
Reaction to gate start
34
Value range
Check box:
• Enable
• Disable
14 to 65535 ms in 1 ms steps
1 to 65534
• Disable
• Enable
• Sin/Cos encoder (A, B, N)
• Sin/Cos encoder (A, B)
• Disable
• Enable
0 to 32767
• No reaction to signal N
• Synchronization at signal N
-2147483647 to 2147483647
-2147483648 to 2147483647
-2147483648 to 2147483646
• Continue counting
• Stop counting
• Start value
• Opposite counting limit
• Set to start value
• Continue with current value
Default setting Parameter
reassign-
ment in
RUN
Disable No
150 ms No
Address supplied by No
F-CPU (Always ena-
bled)
Enable No
Sin/Cos encoder (A, No
B, N)
Disable No
1024 No
No reaction to sig- No
nal N
2147483647 No
0 No
-2147483648 No
Continue counting No
Start value No
Set to start value No
ET 200SP F-TM Count 1x1Vpp sin/cos HF (6ES7136-6CB00-0CA0)
Equipment Manual, V1.0, 01/2021, A5E47073911-AA
Scope
STEP 7 (TIA Portal);
STEP 7; GSD file
Module
Module
Module
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel