Table of Contents
Advertisement
INSTRUMENTS AND CONTROLS
Slow Speed Wipe
By pushing the lever up to the slow speed wiping position
(2), the wipers will operate slowly.
Fast Speed Wipe
By pushing the lever up to the fast speed wiping position
(3), the wipers will operate at fast speed.
Single Wipe
Pressing the lever down to the single wiping position (4)
and releasing will operate a single wipe. If the lever is held
down (4), the wipers will operate continuously until the
lever is released.
Note: When the car is stationary, if the bonnet is
opened, the front wiper/washer operation will be
disabled.
58
IMPORTANT
• Avoid operating the wipers on a dry windscreen.
• In freezing or extremely hot conditions, make sure
that the wiper blades are not frozen or adhered to
the windscreen.
• In winter, remove snow or ice from around the
wiper arms and blades, including the wiped area of
the screen.
Programmed Wipe
Pulling the lever toward the steering wheel (6) will operate
the front windscreen washers. After a short delay, the
wipers will commence operating in conjunction with the
washers.
Note: The wipers continue operating for a further
three wipes after the lever is released. After several
seconds, there will be a further wipe to remove any
fluid draining down the screen.
Advertisement
Table of Contents
