Table of Contents
Advertisement
STARTING & DRIVING
state. The system defaults to the last selected state from
when the START/STOP Switch was ON/READY.
When the lane departure warning system is in the standby
or active state, you can temporarily disable the function by
pressing the button at the end of the indicator stalk switch
(as shown above). Pressing the button again will resume
the function.
When the lane departure warning function is
enabled, the indicator lamp illuminates yellow. When the
function is enabled and the vehicle speed is above 37mph,
the indicator lamp turns green. When the function is
disabled, the system indicator lamp extinguishes. If the
lane departure warning system detects a fault or failure, the
indicator lamp will flash yellow for 90s, and then remain on.
The lane departure warning system will be
impaired in the following conditions:
• The front view camera is obstructed or it is impossible
for the camera to detect the lane line ahead due to
weather and environmental factors.
• The lane line is too thin, damaged, or fuzzy.
228
• The vehicle is driven on the bend with a small curvature
radius.
• The width of the road is too narrow or too wide.
• The vehicle is driven on a road section without lane
lines.
• The vehicle has just entered a road section with lane
lines.
• The vehicle changes lanes.
• The vehicle is not in D.
• The vehicle sways laterally too fast.
• The vehicle speed is below 33mph, or above 93mph.
• The anti-lock brake system (ABS) and the dynamic
stability control system (SCS) are activated.
• Faults exist in the anti-lock brake system (ABS), dynamic
stability control system (SCS), electric power steering
system (EPS), etc.
Advertisement
Table of Contents
