Table of Contents
Advertisement
3 Touch the corresponding button in the infotainment
display to adjust the alert sensitivity.
defaults to the last selected state from when the
START/STOP Switch was ON/READY.
4 Touch the corresponding button in the infotainment
display to turn the vibration alert ON/OFF. The
system defaults to the last selected state from when
the START/STOP Switch was ON/READY.
Having turned the lane departure prevention system on
The system
in the infotainment display, press the button at the end
of the indicator stalk switch (as shown above). The lane
departure prevention system will enter the standby or
active state. The system defaults to the last selected state
from when the START/STOP Switch was ON/READY.
When the lane departure prevention system is in the
standby or active state, you can temporarily disable the
function by pressing the button at the end of the indicator
stalk switch (as shown above). Pressing the button again
will resume the function.
enabled, the indicator lamp illuminates yellow. When the
function is enabled and the vehicle speed is above 37mph,
the indicator lamp turns green. When the function is
disabled, the system indicator lamp extinguishes. If the lane
departure prevention system detects a fault or failure, the
indicator lamp will flash yellow for 90s, and then remain on.
STARTING & DRIVING
When the lane departure prevention function is
4
231
Advertisement
Table of Contents
