Reverse Lamp Bulb Renewal
1 Disconnect the battery negative terminal.
2 For reverse lamp bulb replacement, it is necessary to
remove the rear bumper cover, seek guidance from an
MG Authorised Repairer.
3 Rotate the bulb holder anti-clockwise and remove.
4 Remove the bulb from the holder.
5 Install new bulb into the holder.
6 Locate the bulb holder in the lamp, rotate clockwise
until fully secured.
7 Fit the rear bumper.
8 Connect the negative battery terminal.
EMERGENCY INFORMATION
9 Test lamp operation.
5
287