Table of Contents
Advertisement
MG Pilot system setting
1
The operating interface for the MG Pilot system is located
in the infotainment display.
interface to locate the driving assist option, scroll across
the page to find the setting interface for the MG Pilot
system. The driver may select to turn it on/off. To use
the MG Pilot system, the adaptive cruise control system
must be turned on at the same time. When the function
2
Enter the vehicle setting
STARTING & DRIVING
is turned off, the message centre in the instrument pack
will display the corresponding prompt.
Turn the adaptive cruise control level to "RESUME" twice
will switch the MG Pilot system from standby to active
state.
When the MG Pilot function is enabled, the
indicator lamp illuminates yellow. When the function is
active, the indicator lamp illuminates green. When the
function is disabled, the system indicator lamp extinguishes.
If the MG Pilot system detects a fault or failure, the
indicator lamp will flash yellow for 90s, and then remain
on.
Technical requirements for using MG Pilot
system:
• The adaptive cruise control system must be activated.
• The MG Pilot system must be switched on via the
corresponding button in the infotainment system.
• If the vehicle speed is below 37mph, the system must
be able to detect lane lines on both sides of the vehicle
or a target vehicle directly ahead.
4
239
Advertisement
Table of Contents
