Table of Contents
Advertisement
STARTING & DRIVING
Speed assistance system setting
The operating interface for the speed assistance system
is located in the infotainment display. Enter the vehicle
setting interface to locate the driving assist option, scroll
across the page to find the setting interface for the speed
assistance system:
1 Touch the corresponding button on the infotainment
display to select the speed assist mode:
limit information function, manual speed assist and
intelligent speed assist.
Speed settings of manual speed assist:
After the manual speed assist function is enabled, the speed
limit value can be set by using the adaptive cruise control
lever as follows:
1 Moving the control lever up to adjust the speed
limit. After the speed limit value is displayed in the
instrument pack, press the SET button (3 in the
figure below), the manual speed assist function will be
activated. When pressing the SET button, if the actual
speed value is smaller than setting, the speed limit
value displayed in the instrument pack will be defined
222
as setting. If the actual speed value is larger than
speed limit adjusted, the speed limit value displayed
in the instrument pack will be defined as the current
actual speed and rounded to the nearest value of
5mph (62mph will be defined as 65mph). The speed
range is 20mph - 80mph. Moving the lever up or down
once will increase or decrease the speed limit value by
5mph. Holding the lever up or down will continuously
speed
change the speed limit value in units of 5mph.
2 After the manual speed assist function is activated,
the system will actively intervene and keep the vehicle
speed within the target speed limit. If the current
actual speed exceeds the target speed limit value set
by the driver, the system will reduce the speed untill it
is below the target speed limit.
3 After the manual speed assist function is activated, the
driver can press the SET button (3 in the figure below)
on the adaptive cruise control lever to reinstate the
system to standby state. Press the SET button again,
the manual speed assist function will be resumed.
Advertisement
Table of Contents
