Table of Contents
Advertisement
EMERGENCY INFORMATION
valve. Ensure that the power switch of the electric
air compressor is switched off (i.e., press "O"), then
insert the plug from the compressor into the centre
console power socket, and turn the START/STOP
Switch to ON/READY.
Note:
To avoid battery discharge,
recommended to keep the vehicle in P and READY
mode.
264
3 Switch on the switch of the electric compressor
(i.e., press "-"), to start pumping sealant into the
tyre. The tyre sealant bottle will become empty after
approximately 30 seconds. The tyre should reach the
specified pressure within 5 or 10 minutes.
Note: The pressure gauge may briefly reach 6
bar (87 psi), then the pressure begins to drop to
normal.
4 When the required pressure is reached, switch off the
power switch of the electric compressor (i.e., press
"O").
Note:
If the required pressure cannot be
reached within 10 minutes, please disconnect the
compressor, drive the vehicle 10 metres (33 feet)
approx forward or backward to allow the sealant
to spread within the tyre. If the required pressure
can still not be reached, the tyre is severely
damaged and you should seek assistance from the
it is
MG Authorised Repairer.
Advertisement
Table of Contents
