Table of Contents
Advertisement
EMERGENCY INFORMATION
domed head of the jack must fit into the corresponding
recess in the sill plate (There is a triangle indicator in the
area shown by the arrowhead. See the illustration above).
Turning the jack screw by hand, adjust the jack until the jack
head fits snugly onto the sill in the correct area. Ensure that
the base of the jack is in full contact with the level ground.
Fitting the Spare Wheel
Regularly check the spare wheel tyre
pressure, it may not be used for long
periods of time. After fitment, at the first
opportunity check and adjust the tyre
pressure.
The wheel bolts must be tightened to the
specified torque after changing a wheel
～ ～ ～
(120
130 Nm).
1 Before raising the car, use the special tool supplied
with the vehicle to remove each wheel bolt cap. Use
the wheel bolt spanner to slacken each bolt half a turn
anti-clockwise.
268
2 Turn the handle in a clockwise direction until the tyre
is clear of the ground.
3 Remove the wheel bolts and place them in the tool tray
to prevent them from being lost. Make sure the vehicle
is steady and there is no risk of slip or movement
before removing wheel bolts.
4 Remove the road wheel.
Note: Avoid placing wheels face down on the
ground - the surface may be scratched.
5 Fit the spare wheel and tighten the wheel bolts with
wheel bolt spanner until the wheel is seated firmly
against the hub.
6 Lower the car and remove the jack, then FULLY tighten
the wheel bolts in a diagonal sequence.
7 Finally, return the tools to the toolbox, put the toolbox
into the well of the boot floor, tighten the spare wheel
retaining nuts, and put the replaced wheel above the
toolbox in the well in the load space floor (face down).
Lower the boot floor, and put the boot storage box on
the boot floor.
Advertisement
Table of Contents
