Charge The Battery; Use The Optional Charging Base - Moneris Go Setting Up

Table of Contents

Advertisement

Charge the battery

Charge the terminal's internal battery for 3 hours using one of the following methods:
Charging cable (see page 5).
Optional charging base (see below)
Recommendations: You must use the exact power adaptor and cables provided by Moneris to work with the
Moneris Go terminal and base. Failure to do so may affect the operability of, or cause damage to, the equipment.
Always plug the charging cable into the power source last to avoid power surges. Use a power bar equipped with
surge protection where possible.

Use the optional charging base

1. Unfold the charging cable and insert the USB connector into the USB
port in the back of the base.
2. Make sure the AC adaptor is connected to the other end of the
charging cable. Plug the AC adaptor into a working electrical outlet on a
power bar.
3. Dock the terminal on the base. Ensure that the metal contacts on the
underside of the terminal fit securely over the leads prong on the base.
4. The terminal displays the charging screen.
a. Wait for the battery icon to display the lightning bolt symbol. This
indicates that the terminal is receiving power and the battery is
charging.
b. Continue charging the terminal during the rest of the setup
procedures.
5. Refer to Power on the terminal on page 5.
Moneris Go®: Setting up Your Terminal
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Moneris Go and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents