Kogan KASPAMSDLTA User Manual page 16

IMPORTANT: The following conditions will lead to slow water heating
•
The ambient temperature is lower than 10°C.
• Outdoor wind speed is above 3.5-5.4m/s (8-12mph).
•
The air bubble function is activated when heater is on.
• The spa is not properly covered with the spa cover when the heater is on.
Bubble Button: To activate the bubbling massage function. The
light of Bubble button displays green when activated. The
bubbling will be shut down automatically after every 20 minutes
operation for safety concern. It can be re-activated 10 minutes
after shutdown.
Attention: The bubble function can only be activated when the
inflation knob is in <OFF> position.
Adjustment Buttons: Press UP or DOWN button, the screen
flashes setting temperature. Re-set the temperature within 3s.
Otherwise the temperature setting mode will automatically end.
If other button is pressed during the setting, the setting will also
stop. The current temperature shown on the screen is confirmed.
NOTE: Default setting temperature is 38°C; Temperature setting
range: 20 - 40°C.
Controller Locking: Press UP and DOWN button at the same
time for 3s, the buzzer will ring 3 times, meaning that the
controller is locked. In this mode, function will not be turned on if
the button is pressed. Press UP and DOWN button at the same
time again for 3s to unlock the controller.
Timer Button: Press the TIMER button to enter intelligent pre-
setting mode. By pressing UP and DOWN button, you can set
and start heating automatically in up to 99 hours. The TIMER
setting is confirmed if no further operation in more than 3s or
press TIMER button again. The heater will start working after
current setting hours. The setting hour can also be changed by
entering the pre-setting mode again. The light of TIMER button
flashes green when activated.
To cancel, press the TIMER button for 3s to cancel the pre-
setting.
NOTE: The pre-setting function cannot be turned on during
heating process. The pre-setting mode will also end after
heating function is on or after the spa is reboot.
Filter Cartridge Cleaning Reminder: When red light keeps
flashing (Filter function is OFF) or red and green lights alternately
flashing (Filter function is ON), the filter cartridge shall be
cleaned or replaced. After that, press Filter button for 3s to delete
the reminder.