Table of Contents
Advertisement
INSTALLATION
1. Move the entire package to a selected site. Open the carton carefully as it can be re-
used to store the spa during long term storage or when not in use.
2. Lay out all the parts on the ground and make sure all parts are accounted for. Make
sure the spa tub is right side up.
3. Heater Resetting
Please reset the heater when the product is
used for the first time or after a long period
of storage.
Find the yellow ring as shown in the picture.
Pull it down gently and then release it.
Note:
The heater cannot work or be reset
when the water temperature or ambient
temperature is higher than 40°C.
4. Spa Inflation
•
Plug the spa into the grounded supply socket.
•
Press RESET button on the PRCD, the screen on controller shows numbers.
•
Turn the inflation knob to the inflation status ON and long press (>2 minutes) the
bubble button on the controller to start inflating until the yellow section of the
manometer is pushed out.
•
Stop pressing the bubble button and turn the knob back to OFF for activating other
functions.
On
Bubble
Yellow
Off
Advertisement
Table of Contents
