Table of Contents
Advertisement
CLEANING & CARE
Spa Drainage
1.
Turn off all the buttons (heater, filter and bubble) on the control panel unit.
2.
Connect the drain valve adapter to a garden hose and point the other end of the
garden hose to a suitable draining area with local environmental regulations (Fig.1)
3.
Remove the drain valve cap from the outside of the spa tub and attach the drain
valve adapter with the garden hose to the drain valve (Fig.2)
4.
From the inside of the spa tub, open the drain valve cap, water will start to flow out
through the garden hose (Fig.3)
5.
When the water stops draining, lift the spa tub wall from the opposite to the drain,
leading any remaining water to the drain and empty the spa water completely.
(Fig.4)
6.
Press
Bubble button to dry out any water in the piping system. Operate the
bubbling function for 15 minutes to blow out all the remaining water. (Fig.5)
7.
Use a clean towel to wipe up any remaining water and moisture on the spa tub and
spa control panel. (Fig.6)
Garden
Hose
Minutes
Advertisement
Table of Contents
