Table of Contents
Advertisement
FIRST USE AND SET-UP PREPARATION
Site preparation and requirements
•
The spa can be installed indoor and outdoor around 10 minutes by at least one
person. For household use only.
•
The spa must be set up on a flat, smooth and supporting surface that can support
the maximum load of the filled spa with listed maximum occupants.
•
Make sure the area is free of sharp objects under or around the spa. Uneven or
unsound surfaces can damage the spa and void your warranty. Level the surface
before filling spa with water.
•
Provide adequate drainage system around the spa to deal with overflow water and
splashes.
•
Make sure there is enough clearance around the spa for full access to the spa
equipment for maintenance and/or service.
Additional requirements for indoor installation
•
Verify the supporting floor can support the filled weight of spa with maximum
number of occupants. Check with a qualified contractor or structural engineer to
verify the requirement.
•
Make sure the floor is water resistant and provides non-slip surface. Do not install
the spa on a carpet or any other material that could be damaged by the moisture.
•
Humidity is a natural side effect of indoor spa installation. The room shall be
properly ventilated to allow moisture to escape. Install a ventilating system to
prevent excess condensation moisture in the room.
Additional requirements for outdoor installation
•
Make sure to set up the spa on a firm, level and smooth surface that is strong
enough to support the full weight of the filled spa and maximum occupants.
•
Do not set up the spa on grass or dirt, as this increases the amount of debris
entering the spa and damage the spa floor.
•
Do not leave the spa tub exposed to direct sun light for longer lifespan.
•
Always keep the manometer on yellow section when using the spa at a
temperature higher than 20°C or exposed to sunlight for a short time.
•
It is recommended to install and leave the spa outside at a temperature not lower
than 4°C to ensure the water inside the circulation system, pump, pipe are not
frozen. Put a Heat Preservation Mat between the spa bottom and the ground to
prevent heat loss from the bottom of the spa and to provide better heat retention.
Advertisement
Table of Contents
