Overview Of Installation Steps - Intec ColorCut FB550 Series Installation & Setup Manual

3.0.1 OVERVIEW of installation steps

01
02
03
04
05
06
Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 19
INSTALLATION
START
Assembly
Assemble the stand, mount the intec ColorCut onto the stand. Fit the hose
connectors to the ColorCut engine and Vacuum pump then connect the hose.
Install the Software
Install the supplied ColorCut software for Illustrator or CorelDRAW.
(Refer to your ColorCut Pro Software manual).
Connect to your Computer
Using the supplied USB cable connect the cutter to your PC or Mac.
Then check in the software that the cutter can be seen.
Install ColorCut Flatbed Tools
Install the Blade Creasing and Pen Tools.
Calibrating the Cutter
Turn your cutter on, then calibrate first the Creasing tool position to the
cutting tool. Next refer to your ColorCut pro software manual and set the
offset from sensor to cutting position in your software.
Load media and perform test cut
Select your cutting matt, (Felt or Green matt) and load your media .
Use TEST cut to perform a cutting test and adjust blade if necessary.
(Please refer to your ColorCut Prosoftware Manual.
INSTALLATION
FINISHED