Intec ColorCut FB550 Series Installation & Setup Manual page 33

3.5.1 Calibration of the Creasing Tool to the Cutting Tool (cont)
10
. Click the
button on the tab strip acr oss the
bottom of the LCD screen.
Tool2 (The Creasing Tool) will crease
a box at 45
shape). Tool1 (The Calibration Pen)
will then draw a BOX ar ound the
Diamond shape. .
12
. When it has finished drawing the
box and creasing the second box,
press the
display the MOVE X: Y ; SCREEN
and use the Left/RIGHT arrow keys
to move the beam and tool carriage
so you can r eview the shapes
drawn/creased.
13
14
. Press the
the bottom of the LCD display, ensure
"Align Tool2 to T ool1" is selected
(has the arrow next to it, and click the
[ENTER] key to r eturn to the Align
Tool2 to Tool1 calibration settings.
15
. Using the arrow keys, (Left / Right) to adjust the X value to move the position Left
or Right across the Table.
parameter to move the position towards the operator or away from the operator.
Press the [Enter] key to accept your values. Repeat fr om Step.4 until you achieve
a perfect fit between the two tools.
(Remember to select a new origin each time to avoid making a test in the same position. Do this by using the
MOVE menu to move the tool carriage over your paper and pressing [Enter] twice to select the new origin)
Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 33
[TEST CUT] tab
rotation  (a Diamond
O
MOVE/
TAB to
. If both tools ar e aligned the cr eased box will fit perfectly inside
the DRAWN box. If they do, Tool2 is aligned to Tool1 please press
the HOME tab key and continue to section 3.5.2 (Calibrating the
Sensor Offset)
If they ar e not aligned perfectly , continue as detailed below to
adjust the alignment.
[MENU] Tab button on
Use the Up/Down keys to adjust the value of the Y