Intec ColorCut FB550 Series Installation & Setup Manual page 32

3.5.1 Calibration of the Creasing Tool to the Cutting Tool (cont)
6.
Set the pressure for the Creasing Tool
so that it is easy to see the crease.
(In step 5 you pressed [Enter] twice
so the display should now show
HOME SCREEN- If the display is
showing MOVE X: xx , Y:xx, then
press the [ENTER] x2 key to bring
the cutter back online.)
Press the 'touchscreen' panel on
TOOL2.
Then use the UP / DOWN keys to set the speed (to 300mm/s)) and use the Left /
Right keys to set the Force. (to 960 g)
The press the [ENTER] key to accept the settings.
7.
Now press
button on the bottom of the LCD
display to open the menu/setting
screen.
8.
Ensure the " Align Tool2 to Tool1"
is selected (has the arrow next to it,
and click the [ENTER] key to select.
Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 32
7.
pressure or you may break the pen).
Press the 'touchscreen' panel on
TOOL1.
Use the UP / DOWN keys to set the
speed. (to 600mm/s))
Use the Left / Right keys to set the
Force. (to 280 g)
The press the [ENTER] key to accept.
[MENU] Tab
9.
the calibration.
Set the appropriate pressure for the
Calibration Pen Tool (not too much
The "Align Tool2 to Tool1" screen
will appear to guide you thr ough