The tool carriage is mounted on the beam that travels across the cutting area.
It contains 2 tool holders enabling 2 dif ferent tools to be mounted at the same time for
different operations'
Ⓑ
1.
To install a tool into your Intec ColorCut Flatbed, loosen the tool holder's thumb
Ⓒ
screw
sufficiently to enable a blade holder / creasing tool or calibration pen to
be inserted up to its flange
Ⓒ
2.
Push the tool, i.e. the Blade Holder , Creasing Tool or Calibration Pen all the way
into the tool holder until its flange completely touches the upper part of the holde . .
Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 29
Tool holder
Bracket to hold tool
Top
The Tool Holder
typically the cutting blade.
The tool holder furthest away from the beam
TOOL2 (typically the Creasing Tool).
Ⓐ
Bracket to hold tool
Tool holder
Tool holder
Ⓒ
Bracket to hold tool
Top
Bracket to
hold tool
3.
Make sure that the tool bracket is engaged on top of