Intec ColorCut FB550 Series Installation & Setup Manual page 35

3.5.2 Calibration of the Sensor Offset to the Cutting Blade
4.
Place a Blank sheet of A4
/ US Letter paper in the
middle of the cutting table.
6.
Using the Left / Right physical
keys move the beam over the
sheet of paper, then using the Up /
Down keys move the Tool Carriage
to the middle of the piece of paper .
Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 35
5.
Turn on the vacuum hold, by
pressing the Vacuum Tab [
(Fan) key on TAB strip at the base of the
LCD control panel.
7.
With the Tool Carriage in the middle
of the sheet of paper
[ENTER] key twice to set a new
ORIGIN point
key the second time, TOOL2 will briefly
activate to confirm).
After pressing [ENTER] 2x the
display will r eturn to the HOME
screen showing the T ools and their
Speed and Force settings.
, press the
(When you press ENTER
]