Table of Contents
Advertisement
1.6 THE CONTROL PANEL (Overview of Navigation)
⑩
⑪
①
LED Display Displays Tool (Cut/Crease) information and menu parameters.
②
(Fan)
③
/ MOVE
④
(Home)
⑤
Menu
⑥
Test
Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 12
⑨
TOOL 1 - SPEED / FORCE - Controls the speed and force of tool holder 1.
(Generally used to hold the blade for cutting).
TOOL 2 - SPEED / FORCE - Control the speed and force of tool holder 2.
(Generally holds the creasing tool).
Tap on the screen to select each tool, use the HARD keys (left) to adjust values.
Toggles the vacuum fan function on/off [
Takes the Cutter [Of f-Line] and enables your to move the tool
carriage. Used to set the start/origin for cutting and moving the
carriage when placing sheets. After moving the tool carriage, you
must press ENTER twice if you want to define the position as a new
ORIGIN. The MOVE function also enables access to the Sensor light
ON/OFF button
HOME - Returns back to the main screen.
(When you use the MOVE function or scroll through the menu options, pressing
the [
] (HOME) key leaves the screen and returns to the HOME screen.
(Default Home screen displays: Speed and Force - (for each Tool)
Scrolls through the machines menu settings/parameters.
Align Tool2 to Tool1 - Sets the distance between tool holder 1 & tool holder 2.
Enabling you to align the CREASE to the CUT . This is not the same as cutting
in the correct position (see SENSOR OFFSET) in your software manual for that!.
Firmware Version - Displays the current installed version of firmwa e
Menu Mode - Displays the DEFAULT list (above) or ADVANCED list (below)
Work Mode
- Cut Plotter
- Draw Plotter - Enables tool holder 1 (blade/cut ) only.
Scaling Factor - Scaling for the X direction and Y direction.
- Set at the factory , and typically does not need to be changed.
Factory Reset - Restores ALL factory default settings.
Used to make a T est Cut to check whether the curr e ntly selected cutting
conditions are compatible with the media loaded. Tool 2 creases a 45
rotated square (Like a diamond), then Tool 1 cuts a square around it.
Using a Test Cut you can check Blade Depth and pr essure for cutting
and also confirm if the creasing Tool is perfectly aligned to Cutting T ool.
Offline
Enter
⑦
⑧
②
(enabling you to see the sensor position).
- Enables both tool holder 1 and tool holder 2.
⑤
⑥
③
④
] /[
]
.
①
O
Hide quick links:
Advertisement
Table of Contents
