Performing A Test Cut; Calibration Of The Creasing Tool To The Cutting Tool - Intec ColorCut FB550 Series Installation & Setup Manual

3.6 Performing a test cut

The installation of your ColorCut FB550 is almost complete. The final step befo e starting
to learn how to Design, Create and Cut your files using the ColorCut Po software guide
(manual 2) is to fit the blade tool in Tool position1 in place of the Calibration Pen tool
and check your Blade depth for the medai your will be cutting by performing a test cut.
1.
Refer to section 2.4 - Blade Adjustment. Install the appropriate cutting
blade in the Blade holder.
Bracket to hold tool
Top
2.
Still referring to section 2.4 - Blade Adjustment. Set the blade exposure
by adjusting the know at the end of the Blade holder . (Remembering, SET
THE BLADE DEPTH/EXPOSURE TO THE LEAST AMOUNT POSSIBLE.
MOVE/
Using the Left / Right keys move the carriage so that you can place a sheet of
paper on the cutting bed.
5.
Turn on the vacuum hold,
by pressing the Vacuum Tab
[ ] (Fan) key on TAB strip
at the base of the LCD contr ol
panel.
6.
Using the
physical keys move the beam
over the sheet of paper, then
using the Up / Down keys,
move the Tool Carriage to the
middle of the piece of paper.
Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 37
Tool holder
Tool holder
Bracket to hold tool
Less is MUCH better than more).
3.
Refer to section 3.4 - Installing the Tools. Install the Blade
holder in to the Tool carriage in Tool position 1.
4.
Place a sheet of the media you plan to cut on the cutting
table . Using the LCD control panel on the cutter, press the
Tab icon along the bottom of the display.
Bracket to
Tool holder
hold tool
Flange
Left / Right