Installation Of The Lc600 Cutter (Overview Of Steps) - Intec ColorCut LC600 Series Installation Manual

Installation of the LC600 Cutter (Overview of steps)

1
2
3
4
5
6
7
Intec Printing Solutions - Manual for ColorCut LC600 Sheet fed Label Cutter .......................................................................... Page No: 9
INSTALLATION
START
Unpacking & positioning the LC600
Unpack the Intec LC600 cutter, check the accessories.
features of the LC600. Then position the cutter with enough room to load media and
for the retractable exit tray to be opened.
Setup Wi-Fi HotSpot
Configure the Wi-Fi Hotspot to receive the Live video feed
(Install provided Wi-Fi dongle if your PC doesn't have Wi-fi capabilities
Install the Software
Install the supplied ColorCut Pro 3 software for Illustrator or CorelDRAW.
(Install Mac client where applicable)
Connect to your Computer
Using the supplied USB cable connect the cutter to your PC. Then
check in the software that the cutter can be seen.
The ColorCut LC600 Tools
Overview of the Blade Holder, and different blade types. Setting the
blade depth. How to install the Blade and Pen Tools.
LCD Panel & Calibrating the Cutter
Turn your cutter on, check Cutter appears on Wi-Fi Hot-Spot, launch ColorCut
Pro & calibrate the sensor to cutting position in your software.
Load media and perform test cut
Use TEST cut to perform a cutting test and adjust blade if necessary.
Load your media and start cutting.
(Please refer to your ColorCut Pro, Cut file design & Daily Operating Manual.
INSTALLATION
FINISHED
Get familiar with the key