Installing Tail Surfaces; Install The Stabs; Install The Vertical Fin - BVM Go Fly Gold Bandit Evo Assembly And Operating Manual

INSTALLING TAIL SURFACES

Install the Stabs

Connect the servo leads and secure
with servo clips or tape.
Insert the Carbon Rods fully into the
receiver brackets.
Secure each stab by tightening the
bolts with a 9/64 ball wrench.

Install the vertical fin

Connect the servo leads and secure
with servo clips or tape.
Insert the Carbon Rods into the
receivers.
BVM ® 2018
Bandit Evo
Assembly & Operation Manual
5 02/27/2018