Table of Contents
Advertisement
3. Place the special spanner SW 14.2 over both
nuts of the pressure regulator and unscrew
them.
4. Screw down the new pressure regulator
gether with the seal in the pneumatic block.
5. Fit the spindle limiter screw cap
– Screw the pressure regulator nuts as far
down as they will go.
– Screw in regulator spindle by hand until it
meets noticeable spring pressure; then un-
screw a quarter of a turn .
– Screw the fixing nuts onto the pressure reg-
ulator housing as far as possible.
– Secure the pressure regulator fixing nuts
with the lock nut.
6. Join the two halves of the housing together
(see "6.2.4 Assembling the housing" on
page 16).
7. Perform a final check (see "3. Final Check" on
page 7).
to-
17
as follows:
18
Repair information and repair instructions
20
51
25
Advertisement
Table of Contents
