M.2 Ssd Module; Removing The M.2 Ssd Module; Installing The M.2 Ssd Module - Dell EMC PowerEdge C6525 Installation And Service Manual

Next steps
1. Replace the air shroud.
2. Follow the procedure listed in

M.2 SSD module

Removing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the M.2 riser.
Steps
1. Using a Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the M.2 riser.
2. Pull the M.2 SSD module to disconnect from the connector on the M.2 riser.
Figure 40. Removing the M.2 SATA card from the M.2 riser
Next steps
1. Install the M.2 SSD module.
.

Installing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
NOTE: The procedure to remove the BOSS card is similar to the removing an expansion card.
Steps
1. Align the M.2 SSD module at an angle with the connector on the M.2 riser.
46 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
Safety instructions.
Before working inside your
system.
system.
system.