Removing The Processor - Dell EMC PowerEdge C6525 Installation And Service Manual

Figure 44. Removing the heat sink
Next steps
1. If you are removing a faulty heat sink,

Removing the processor

Prerequisites
CAUTION: The heat sink may be hot to touch for some time after the system has been powered off. Allow the
heat sink to cool before removing it.
1. Follow the procedure in
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Remove the heat sink.
Steps
1. Using a Torx #T20 screwdriver, loosen the screws to release the force plate. The sequence to loosen the screws is 3, 2, and
1.
50 Installing and removing system components
replace the heat
Safety instructions.
Before working inside your
sink, if not, remove the processor.
system.