After Working Inside Your System; Recommended Tools; Sled; Removing A Sled - Dell EMC PowerEdge C6525 Installation And Service Manual

Steps
1. Power off the system, including all attached peripherals.
2. Disconnect the system from the electrical outlet and disconnect the peripherals.
3. Remove the sled from the enclosure.

After working inside your system

Prerequisites
Follow the safety guidelines listed in
Steps
1. Reconnect the peripherals and connect the system to the electrical outlet.
2. Power on the attached peripherals and then power on the system.

Recommended tools

You need the following tools to perform the removal and installation procedures:
● Key to the bezel lock. The key is required only if your system includes a bezel.
● Phillips #1 screwdriver
● Phillips #2 screwdriver
● Torx #T20 screwdriver
● 5mm hex nut screwdriver
● Plastic scribe
● 1/4 inch flat blade screwdriver
● Wrist grounding strap connected to the ground
● ESD mat

Sled

Removing a sled

Prerequisites
1. Follow the safety guidelines listed in
NOTE: For optimized thermal performance, see
NOTE: The procedure to remove a sled blank or a sled is similar.
Steps
Press the retention latch and holding the sled handle, pull the sled out of the enclosure.
CAUTION: Ensure that the sled is supported with both hands while it is being slid out.
18 Installing and removing system components
Safety instructions.
Safety Instructions.
Sled installation guidelines.