Installing The Liquid Cooling Heat Sink Cover - Dell EMC PowerEdge C6525 Installation And Service Manual

Figure 56. Installing the liquid cooling heat sink with liquid leak sensor
5. Return to the first screw to tighten it.
6. Engage the liquid cooling heat sink with liquid leak sensor tubes on the groves of the liquid cooling heat sink bracket until it is
secured in place.
7. Connect the liquid leak sensor cable on the system board.
NOTE: Liquid leak sensor cable must be connected to the system board, or the entire sensor mechanism does not work.
Next steps
1. Replace the liquid cooling heat sink with liquid leak sensor
2. Follow the procedure listed in the

Installing the liquid cooling heat sink cover

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, remove the air
4. If applicable, remove the heat
Steps
Using a Phillips #1 screw driver, tighten the screws that secure the liquid cooling heat sink cover.
After working inside your
Safety instructions.
Before working inside your
shroud.
sink.
cover.
system.
system.
Installing and removing system components 59