Liquid Cooling Heat Sink With Liquid Leak Sensor; Removing The Liquid Cooling Heat Sink With Liquid Leak Sensor Cover - Dell EMC PowerEdge C6525 Installation And Service Manual

Next steps
1. Install the air shroud.
2. Follow the procedure listed in the

Liquid cooling heat sink with liquid leak sensor

Removing the liquid cooling heat sink with liquid leak sensor cover

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, remove the air
4. If applicable, remove the standard heat
NOTE: The heat sink and processor are too hot to touch for some time after the system has been powered down. Allow the
heat sink and processor to cool down before handling them.
Steps
1. Using a Phillips #1 screw driver, remove the screws that secure the liquid cooling heat sink with liquid leak sensor cover.
Figure 53. Removing the liquid cooling heat sink with liquid leak sensor cover
2. Remove the liquid cooling heat sink with liquid leak sensor cover.
NOTE: If applicable, route and engage the liquid cooling heat sink with liquid leak sensor tubes with the groves in the
liquid cooling heat sink bracket.
Next steps
1. If you are removing a faulty liquid cooling heat sink with liquid leak sensor,
sensor, if not, remove the
2. If you are replacing the liquid cooling heat sink with a standard heat sink
3. If applicable, replace the air
56 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
shroud.
sink.
processor.
shroud.
system.
system.
replace the liquid cooling heat sink with liquid leak
replace the heat sink, if not, remove the processor.