Dell EMC PowerEdge C6525 Installation And Service Manual page 68

Figure 66. Installing the system board
3. Using a 5mm hex nut driver, secure the standoff screws that secure the system board to the chassis.
4. Using a Phillips #1 screw driver, secure the screws that secure the system board to the chassis.
Next steps
1. If not installed, install the Trusted Platform Module (TPM). For information about how to install the TPM, see the Installing
the Trusted Platform Module section. For more information about the TPM, see the Trusted Platform Module section.
NOTE: The TPM plug-in module that is once installed is attached to the system board and cannot be removed. In the
event of a system board replacement, a TPM plug-in module is provided along with the system board for all systems that
have a TPM.
2. Replace the following components:
a. Air shroud
b. Expansion card risers
c. Heat sink module
d. Processor
e. Memory modules
f. OCP card
g. Linking board
3. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4. Follow the procedure that is listed in After working inside your system.
5. Ensure that you:
a. Use the Easy Restore feature to restore the Service Tag. For more information, see the
Restore section.
b. If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see
the Restoring the system using Easy Restore
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). For more information, see the
section.
6. Import your new or existing iDRAC Enterprise license.
68 Installing and removing system components
section.
Restoring the system using Easy
Upgrading the Trusted Platform Module