Figure 33. Installing an expansion card in riser 2
Next steps
1.
Install the expansion card
2. Follow the procedure listed in
Removing the riser card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the expansion card
4. If installed,
remove the expansion
5. If applicable, disconnect the cable from the riser card.
Steps
1. Using a Phillips #2 screwdriver, remove the screws that secure the riser card to the expansion card riser.
riser.
After working inside your
Safety
instructions.
Before working inside your
riser.
card.
system.
system.
Installing and removing system components
41