Table of Contents
Advertisement
Warm-up
The Power-up screen will display two menu items. Pressing Warmup
will start the instrument in the warm-up cycle. This cycle will put the
instrument in a ready state for analysis. Pressing Page will take you to the
First of 3 system setup pages (covered later).
Power On Screen
After pressing Warm-up the instrument will perform a series of system
tests and will begin heating critical zones. The results from these tests will
appear on the Warm-up screen. The Warmup menu item will also change
to Cool. If you wish to stop the Warm-up process, press the Cool key and
the instrument will start to cool down. Do not stop the carrier gas until
all the measured temperatures reach below 50
displayed on the Temperature and Staus screen. If any errors occur during
the Warm-up process the system will stop the Warm-up process. Proceed
to Page 41 - error messages for more detail.
Warm-Up Screen
Cool Mode
Warmup
Warmup Mode
WARM-UP
Module Electronics:
Detector System:
Detector Temperatures:
Carrier Pressure:
Cool
12:34:25
Ver. 2.70
Page
0
C. These temperatures are
12:35:25
Pass
Page
User Manual | 29
Advertisement
Table of Contents
