Electrical Preparations And Connections - Ametek ta3000R User Manual

from air conditioners or extreme temperature fluctuations in the room.
2. Support gases for the instrument should be located near the analyzer.
A uniform temperature environment for cylinders and regulators is es-
sential in order to keep constant pressure and flow rate. Always keep gas
containers inside the building where temperature fluctuations are at a
minimum.
3. Have adequate ventilation around the instrument area without any
high flow velocity draft directly onto the analyzer. If a combustible gas
stream is connected to the instrument it is essential to have proper vent-
ing to avoid any possible explosion hazards. Be sure not to block any vent
slots in the rear or top of the analyzer since limited air circulation will
cause overheating and poor performance.
4. Gas Purifiers for support gases should be installed within 20-30 feet
(6-9 Meters) or less from the analyzer. This minimizes tubing length and
the amount of impurities picked up from the lines.
6. All connections to the instrument should be made with 1/16th inch
stainless steel tubing (maximum 0.030" ID). Coil some extra 1/16th inch
gas lines behind the analyzer. This allows for flexibility when moving or
turning the instrument for service and routine maintenance.
7. Situate the ta3000R in such a way that there is always access to the rear
panel for easy hook up of the gases, as well as ease of service components.
Allow approximately 30 inches service clearance at the rear of the instru-
ment.

Electrical Preparations and Connections

!
CAUTION
1. The electrical requirements for the ta3000R Gas Analyzer can be 100,
115, 220, or 240 VAC, and 50 or 60 Hz, depending on the voltage option
ordered. AC power must be free from cyclic RMS voltage variations,
spikes or drops greater than 1.5%. A minimum of 5 amperes current must
be available.
2. Good grounding of the AC power circuit is required; verify proper
receptacle grounding before connecting the instrument.
Always verify that the voltage on the label located on the rear of the
instrument matches the supplied power before connecting.
User Manual | 21