Connect via Passcode
This option displays a code that must be entered to connect to InstrumentConnect.
Figure 48. Connect via 1-Time Passcode Screen
Note: When using the InstrumentConnect web and mobile
app, ensure you are in the correct regional environment.
If you are in China, you should select the China region.
Refer Connectivity Requirements for details.
If the connection is successful via either of the two methods,
a success message is displayed.
If the connection is unsuccessful, an error message is
displayed. After 5 seconds, the interface will return to the
previous screen. Check the network status and any entered
passwords, etc. and repeat the previous steps to establish a
successful unit connection.
Refer Connectivity Troubleshooting.
Remote Serial
The remote serial tab allows for a MODBUS ASCII protocol to
interface to the unit. Registers that are currently accessible
through this protocol are shown in Appendix D: Modbus
ASCII Parameter Table.
Figure 49. Remote Serial
Ultra Low Temperature Freezers
Operation | 23