Thermo Scientific TSX Series Installation And Operation Manual page 17

The first screen requires acceptance of the terms and
conditions of using connectivity on this device.
If you chose to Skip this acceptance, Wi-Fi connectivity will be
disabled. You can accept the terms and enable connectivity
at a later time via the Connectivity settings menu.
Figure 7. Terms and conditions screen
Select a wireless network and press the Next button.
Figure 8. Wireless Setup Screen
Once the intended network is selected (highlighted), you must
press the Next button.
Note: If you do not want to setup a wireless connection,
press the Skip button. The Date and Time Setup screens will
appear. To setup a wireless connection later, press the 
Settings menu icon and select Connectivity.
The following instruction steps are for WPA2 connection type.
For Enterprise, refer Wi-Fi.
Enter the network password and press the Next button.
12 | Start Up
Figure 9. Wireless Setup (Password) Screen
Note: Press the eye icon
visibility.
Figure 10. On Screen Keyboard
Figure 11. On Screen Keyboard
A success message is displayed once the connection is
established. If the connection fails, either due to an incorrect
Wi-Fi password or network incompatibility, a general error
message is displayed. After 5 seconds, the interface will
return to the previous screen.
Note: If this occurs, check the network status and re-enter
the correct password to establish the connection. 
on the screen for password 
Ultra Low Temperature Freezers