Table of Contents
Advertisement
Hauling the Machine
•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely.
Refer to
Figure 18
and
locations on the machine.
Note:
Load the machine on the trailer with the front
of the machine facing forward. If that is not possible,
secure the machine hood to the frame with a strap,
or remove the hood and transport and secure it
separately; otherwise, the hood may blow off during
transport.
Figure 18
1. Eye hole in the frame (each side)
Figure 19
1. Axle
Figure 19
for the tie-down
2. Hitch plate
Towing the Machine
In case of an emergency, you can tow the machine
for a short distance; however, this is not the standard
operating procedure.
WARNING
Towing at excessive speeds could cause a
loss of steering control, resulting in personal
injury.
Never tow the machine at faster than 8 km/h
(5 mph).
Note:
The power steering does not function,
making it difficult to steer.
Towing the machine is a 2-person job. If you must
move the machine a considerable distance, transport
it on a truck or trailer.
1.
Affix a tow line to the tongue at the front of the
frame of the machine
2.
Move the transmission to the N
and disengage the parking brake.
Towing a Trailer
g009820
The machine is capable of pulling trailers and
attachments of greater weight than the machine itself.
Several types of tow hitches are available for the
machine, depending on your application. Contact your
Authorized Service Dealer for details.
When equipped with a tow hitch bolted onto the
rear axle tube, your machine can tow trailers or
attachments with a maximum gross trailer weight
(GTW) up to 1587 kg (3,500 lb).
Always load a trailer with 60% of the cargo weight in
the front of the trailer. This places approximately 10%
(272 kg (600 lb) maximum) of the gross trailer weight
(GTW) on the tow hitch of the machine.
When hauling cargo or towing a trailer (attachment),
do not overload the machine or trailer. Overloading
can cause poor performance or damage to the brakes,
g009821
axle, engine, transaxle, steering, suspension, body
structure, or tires.
Important:
To reduce potential for drive line
damage, use low range.
When towing fifth-wheel attachments, like a fairway
aerator, always install the wheel bar (included with the
fifth wheel kit) to prevent the front wheels from lifting
off the ground if the towed attachments movement is
suddenly impaired.
29
(Figure
18).
position
EUTRAL
Advertisement
Table of Contents
