Table of Contents
Advertisement
Chapter 4. Operation
b.
Select [UNITS].
c.
Select required pressure units for display using [NEXT], [PREV] and [SAVE].
d.
Use CLEAR/QUIT to return to pressure display.
4.11.2 Change Units in Minimum Setup Mode
a.
Press SETUP.
b.
Select [UNITS TYPE].
c.
Select [PRESS].
d.
Use CLEAR/QUIT to return to the main pressure display.
Note: Pressure units cannot be selected when setup mode is switched off.
4.12 Configuration Options
CONFIG is similar to SETUP with many identical functions. See Appendix A.3 for the CONFIG
menu hierarchy.
The changes made under CONFIG are permanent and remain set after the system is switched
off. CONFIG can be used to change the power-up default settings of the ADTS 405 Mk2
functions.
a.
Hold down the F1 key while pressing SETUP provides access to the CONFIG mode.
CONFIG may be password protected using a four digit PIN. If PIN protected, the
display prompts for entry of the PIN. Press each digit of the PIN in turn (ENTER is not
required) as each digit is entered, an asterisk appears. If an incorrect PIN is entered,
the complete PIN is requested again.
b.
When the correct PIN is entered, the CONFIG menu appears.
Note: The PIN may be changed using CONFIG, -000.
c.
To use the configuration menu, press the appropriate function key to select the
required menu item. To configure a parameter key, enter configuration menu then
press the required parameter key. Each parameter key configuration provides
changes to the normal user mode function and to the settings available in the setup
menu.
d.
Once a parameter has been changed in configuration, use CLEAR/QUIT to return to
the previous menu. After all required key parameters have been changed, repeatedly
press CLEAR/QUIT until the display shows the normal operating mode.
4.13 Communications Panel Options
4.13.1 Ethernet System
The ADTS 405 Mk2 is equipped with an TCP/IP Ethernet interface, and appears on the
network as up to two separate IP addresses. The first IP address relates to the ADTS
instrument supervisor and contains access to the functions described above. The second
address relates to the communications adapter (if fitted). There are no user related functions
40 | ADTS 405 R/F Mk2 Instruction Manual-English
© 2017 General Electric Company – All Rights Reserved.
Advertisement
Table of Contents
