4.2.1 Change to Single, Dual or Triple Display
a.
Press SETUP.
b.
Select [MORE].
c.
Select [DISPLAYS/OPTIONS].
d.
Select [DISPLAY TYPE].
e.
Using [NEXT] or [PREV].
f.
Select either SINGLE, DUAL or TRIPLE, ENCODER (more display types with options
fitted).
g.
Press [SAVE] to accept.
h.
Press CLEAR/QUIT repeatedly to return to user display.
4.2.2 Changing the Display for Pt Only
a.
Press SETUP.
b.
Select [MORE].
c.
Select [Control], [Ps Pt Dual].
d.
Select [Pt Only Mode].
e.
Press CLEAR/QUIT repeatedly to return to user display.
4.3 Changing the Units
In Full Setup Mode any set of aeronautical or pressure units can be selected.
4.3.1 Changing the Measurement Units
a.
Press the SETUP key.
b.
Select [UNITS].
c.
Use [NEXT] and [PREV] keys to select the required units.
d.
Select [SAVE] to accept.
e.
Press CLEAR/QUIT repeatedly to return to the main pressure display.
Note: (1) In Minimum Setup Mode only the default aeronautical and pressure units can
be selected.
Note: (2) If Setup Mode is switched off, units cannot be changed.
4.3.2 Changing the Unit Type
a.
Press the SETUP key.
b.
Select [UNITS TYPE].
c.
Select either [AERO] or [PRESS] to select the unit type.
d.
Select [SAVE] to accept.
e.
Press CLEAR/QUIT repeatedly to return to the main pressure display.
Note: (1) The default pressure and aeronautical units are defined in the CONFIG mode.
© 2017 General Electric Company – All Rights Reserved.
Changing the Units
ADTS 405 R/F Mk2 Instruction Manual-English | 31