Operating Modes; Measure Mode - GE Druck UPS-III User Manual

0.561.8187

Operating Modes

Pressing switches the instrument on and the display shows
the start-up sequence. Pressing
shows the information screen:
F1
Pressing , at this time, the display shows the set-up screen:
F2
F2 Contrast
Resolution
Source unit
Aut power down
Access code
Calibration
The calibrator can be used in two modes measure or source.

Measure mode

The display shows the measured value; depending on the
settings made in set-up and advanced settings:
When measuring current pressing
pressing enables mA or % (value of 4 to 20 mA or 0 to 20
F2
mA).
When measuring voltage pressing
between 0.00V and 0.000V.
To measure continuity the displays shows an open or closed
switch symbol with an audible signal on switch closure.
K0317 Issue No. 3
www.
, at this time, the display
F1
Information
Serial number
VERSION
CAL. DATE
HART
BATTERY
F2
adjust
F2
adjust
F2
Range
4-20 mA/0-20mA
F2
mA/%
F2
Hart® ON/OFF
F2
ON/OFF
. ,
F2
/
Decimal
F2
menu
F2
menu
enables linear or flow,
F1
changes the resolution
F2
4
.com
information@itm.