Change Pressure Units; Voltage And Current Measurement - GE Druck DPI 610 User Manual

Getting Started

Change Pressure Units

To change the pressure units proceed as follows. If the four units displayed are not the
units required, press TASK and select any task, other than BASIC, press SETUP and
proceed as detailed on page 36. To return to BASIC mode, press TASK and select BASIC.
In BASIC mode, the unit is configured to carry out basic Pressure to Voltage (P to V) or
Pressure to Current (P to I) tests, a typical test procedure follows:
Voltage and Current Measurements
Connect the electrical input sockets as follows for voltage and current measurements.
Use the test leads provided and DO NOT push bare wires into the sockets.
+
V
-
Voltage
Maximum applied voltage = 30V dc.
K0430 Issue No. 2
max 30V
Vin
55mA
max
mA in
mA Sink
max 30V
Vin
mA in
mA Sink
Current
Maximum input current = 55mA dc (at 30 V dc)
8
-
+
55mA
max