Table of Contents
Advertisement
Chapter 4. Operation
A ping to either of the above ADTS IP addresses should give the following typical response
seen in Figure 4-7 Ping Test from Windows Command Prompt below:
Figure 4-8: Ping Test From Windows Command Prompt
The IP address settings may be changed to match local network requirements using the
CONFIG and SETUP menus, as described in Section 4.11 and Section 4.12.
An SSH server is available on each IP address for general purpose file access. The factory
default user name and password for accessing the server is:
It is strongly advised that the default password be changed as part of the initial end user
customization.
4.13.2 Changing the Default Access Password
Configure the network interface with an IP address on the same subnet (as described above).
Open an SSH client program. If using a PC then a third party client such as PuTTY may be
used.
Example:
a.
Open the Configuration screen.
42 | ADTS 405 R/F Mk2 Instruction Manual-English
Table 4-2: Default User Name and Password
Parameter
User Name
Password
Value
adts
druk
© 2017 General Electric Company – All Rights Reserved.
Advertisement
Table of Contents
