Asus Terminator K7 User Manual page 58

8. Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable.
After connecting the single end to the board, connect the two
plugs on the other end to the floppy drives. (Pin 5 is removed to
prevent inserting in the wrong orientation when using ribbon
cables with pin 5 plugged).
A7VC Floppy Disk Drive
Connector
9. Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN
output, such as the ASUS PCI-L101 Ethernet card (see 7.
Appendix). The connector powers up the system when a wakeup
packet or signal is received through the LAN card.
IMPORTANT: To use this feature, enable the Wake-On-LAN
feature in BIOS (see 5.5.1 Power Up Control) and make sure
that system has an ATX power supply with at least 720mA +5V
standby power.
A7VC Wake-On-LAN Connector
58
A7VC
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
IMPORTANT: Requires an ATX power
A7VC
supply with at least 720mA +5 volt
standby power
® +5 Volt Standby
Chapter 3: Motherboard Information
FLOPPY
PIN 1
WOLCON
PME
Ground